For row one knock off the flanges with a hammer and chisel so the.
How to do a concrete retaining wall.
How to build a concrete wall figure a.
How to do it build and prep footing.
If you re building a long wall build the frame in sections.
Build the footing and insert.
Of compacted base 1 in.
Drive a nail into the concrete here.
Finish the surface of the wall as desired.
If your frame is tall you may need to begin.
So if your wall is 8 inches wide your two nails should be 8 inches apart.
Measure out from that nail to where the other face of your wall will be and place another nail.
Refer to the plan or schematic for the retaining wall.
See below for more information on contraction joints remove forms and install waterproofing and drainage system.
Lay out the wall and excavate the slope and the footing trench.
Prepare the foundation step 1.
To bury the first row.
The concrete retaining wall is often a dull gray color or whitewashed but you can stain it to be many other colors.
Like the flagstone patio.
Measure and mark footing locations.
Of leveling sand and half the height of the first course of blocks.
Rest the frame pieces against a solid surface to prevent them from falling.
Scrape off excess mortar.
With the layout marked you can begin digging the trench.
Tall wall excavate a trench deep enough to accommodate 4 to 6 in.
If you re building your own forms you will probably.
Cross section of a retaining wall a cinder block retaining wall is only as straight and solid as the base it s built on.
Measure from the edge of your concrete footing to the point where the outside face of your wall will be.
How to pour a concrete retaining wall.
Allow concrete to cure.
Follow the simple steps below to safely and effectively stain your concrete retaining wall.
If the wall exceeds four feet in height footings should be poured separately.
Then use the marking paint and measuring tape to lay.
Try to make the frame pieces as long as you need them to be.
Dig for the first row of block.
Adjust for sloping ground.