How To Fill In Old Door Jambs For Lock

Tap the piece of wood into the hole with a hammer until its face is flush with the face of the door or door jamb that is being patched.

How to fill in old door jambs for lock.

Brush or vacuum out all of the dust and sawdust so the wood surface is clean. Use wood caulking and place it inside the holes. The wood does not need. Sand rough or splintered edges in the mortise area.

How to fill holes left when a door strike was moved. The mortise will be located in the knob edge of the door about halfway up from the floor. I sanded it down to size once it was glued in. In addition to the slot cut for the mortise lock.

Coat the surfaces of the piece that will be going into the hole with glue. A dowel of the proper diameter works well for the rounded hole in the door edge left by the. If you want to cover over these holes then you can do so quickly with a few simple household tools. Step 1 fill in the hole before you can fit any covers over the holes you will first need to add some caulking to the wood in order to prevent the wood splitting during temperature changes.

After i sanded this to the correct size i used a chop saw to cut it to the correct thickness by cutting off the piece with the bolt through it. Remove the plate and all of the old hardware from the strike area. Mix the epoxy. Fill any remaining spaces around the patch with wood filler.

Filling a mortise from an old lock is the essential first step to installing a new lock or using the door for other purposes such as a desktop or other use.