How To Fix Old Garage Door Spring

Position a sturdy ladder to the side of the springs rather than working directly in front of them for safety reasons.

How to fix old garage door spring.

This video will show you how to repair a mis aligned garage door cable. Test the spring by lifting the door about 3 feet. Put on eye. Disconnect the garage door opener so the door remains closed.

Leave the locking pliers in place and repeat the tightening procedure on the other side. If your garage door cable is at an angle or l. Open the door to relieve the spring tension and secure it open with c clamps in the tracks. Pull the cable as tight as possible before tightening the setscrews.

This video is to inform you of a type of spring and bracket that exists on one piece garage doors with a jam pivot style design. This system is unsafe and sh. Install the new spring reinstall the pulley and reconnect the safety cable and you re done. Disconnect the spring from the track bracket and the spring pulley and disconnect the safety cable from one end.

If the door was closing too quickly move the spring to the next higher hole on the bracket. Adjust the springs on both sides of the door the same way. If the door remains in place the replacement was a. The general process is simple and safe.

Use locking pliers or a c clamp to secure the door to the track to keep it from opening when you release the tension on the springs 1 x research sourcestep 2 loosen the set screws while holding each spring with a winding bar. Snap a locking pliers onto the torsion tube to lock it into place while you tighten the drums. Step 1 unplug the garage door opener and clamp the door to the track. Rotate the drum to wind the cable into the winding grooves.

Diy garage door repair and save money. If it was opening too quickly move it to the next lower hole.