From here lift the garage door by hand about 3 feet above the ground and then release the door and see were it lands.
How to fix garage door not opening all the way.
Your garage door has set limit switches that instruct the motor when to stop running both when it is opening and when it is closing.
When closed the weatherstripping on the bottom edge of the door should be in contact with the ground.
You should now be able to move the door up and down by hand.
The spring s do the heavy lifting the opener just assists with the opening and closing of the garage door.
If your door doesn t come down that far you can adjust the automatic opener until it does.
Check to make sure that it hasn t been unintentionally disconnected.
Garage doors come with a disconnect switch or cord so you can operate your door manually in the event of a power outage.
If your garage door is not balanced right it won t go up or down all the way.
Normally your garage door opener takes care of this for you by keeping the door pushed down to the bottom of the garage floor.
Your garage door opener is designed to stop.
To check the balance pull the emergency release cord or chain to disconnect the door.
This had the effect that the metal hook is now almost at the motor and when i manually open the garage the plastic catch does not reach the metal hook to fit it in place.
If you must wait for a repair don t forget to lock your garage door for security.
If your garage door isn t opening to let your car out in the morning or back in at the end of the day follow this troubleshooting guide to find the fix be it a diy or a professional one.
Garage door won t close all the way if the garage door opens correctly but fails to close completely there may be one of three common causes.
The close limit switch may need adjusting.
If the motor is running but the door won t budge your garage door may be locked.
The first thing i would recommend doing is testing the door for balance and anything that might be binding the door.