These types of locks will be used on interior doors.
How to fix door handle that isn t level.
There is still likely to be an actuator on the side of the door that leads to the room where privacy is desired.
If the latch contacts the strike plate at the correct level but doesn t go in far enough or if the latch strikes more than 1 8 in.
Tighten the screw using the appropriate flathead screwdriver or hex wrench.
There should be 2 screws holding on each handle and once unscrewed they should come off easily.
If the screws are not readily visible they are covered by a circular decorative cover this can be gently pried away using a flat blade screwdriver and then the screws will be exposed so the handles can be removed.
Okay so how do we go about aligning the latch bolt and strike plate opening.
The actuator is likely to be a turning or push button switch.
It may be on the underside of the knob.
This type is usually found on round doorknob hardware sets.
That s because modern door hardware uses a hidden mechanism called a detent to fasten the doorknob that can only be released using a small screwdriver tip or the end of a paper clip depending on your style of hardware.
To depress the detent use the end of a metal paper clip or the point of an awl inserting it into the hole and pressing the detent down while twisting and removing the door handle shaft off the spindle.
Let s fix the door latch problem for good.
That s done by hiding the screws under a decorative cover plate that pops off but getting the doorknob off or lever in this case can be frustrating when there is no visible way to remove it.
You can move the strike plate up or down and in or out.
Look for the set screw on neck of the knob between the handle and door.
Be careful so you don t chip any door paint.
Neat stuff isn t it.
To depress the detent insert a small flat blade screwdriver through the slot to press and release the detent while twisting and removing the.
Remove the door rose by inserting a small screwdriver into the small notch in the rose and twisting the tool to pop it off.
Well there are actually a few ways and they all lead to adjusting the door either up or down slightly so it properly aligns.
This type is found commonly on lever style door handles.
Use a sharp chisel to enlarge the strike plate mortise.
Using an awl or small screwdriver push the button in all the way and at the same time pull off the handle.
Use your screwdriver and take off the handles from the door.
