Today we are discussing how to remove an entry mortise lock with a thumb latch on the exterior instead of a regular knob.
How to fix a mortise door lock.
The fix a short term fix is to move the strike plate to align better with the stuck door latch.
Hold down the spray button until the wd 40 begins to overflow from the lock opening.
2 hold the knob on the other side of the door and turn the loose knob clockwise until it fits snugly.
If the latch sticks the knob may be screwed on too tight.
Make a series of closely spaced cuts into the mortise area.
1 loosen the setscrew on the knob s shank.
Soften the paint.
Lightly sand the patched areas.
Pull the knob off the shaft.
This screw should hold the knob securely to the spindle when you turn the knob.
Loosen the setscrew securing either one of the doorknobs to the square knob shaft.
Starting at the top of the faceplate outline make a series of closely spaced chisel cuts about 1 8 inch deep inside the marks.
Examine the mortise lock.
From there you can either widen the hole both of the wood and metal or you can unscrew the strike and re secure it in the proper position.
How to fix antique mortise door mechanisms 1.
Place strips of tape around the exterior and interior patched holes to protect the finish on the door.
To remove a mortise lock set cylinder for repair see illustration for how to tighten a loose doorknob remove the deadbolt knob by loosening the setscrew in the sleeve of the knob using a standard screwdriver or allen hex wrench or by removing any mounting screws.
Cut through the base of the cuts to empty the mortise of excess wood.
Do the same for the recessed patch on the edge of the door.
Then on the faceplate loosen the setscrew opposite the lock cylinder and unscrew the lock cylinder.
Notice the set screw on the base of the knob on the right.
Press down on the button on the rear of the wd 40 canister to begin releasing the lubricant into the lock.
Don t be afraid to use a liberal amount of oil a sticky lock needs the attention.
If you have questions please ask.
This mortise lock set is installed in a 1930 colonial in the boston area.
3 if this does not help remove the knob.
The knob and or the spindle may.
You can tighten a simple interior mortise lockset like the one shown at left as follows.
If the thumbturn for the deadbolt is causing the bolt to jam and lock you out when it s in the wrong position you may.
Try loosening the flathead screw on the base of your doorknob.
The easiest fixes are.
Meet the mortise lock and door knobs.
