Check to make sure there are no electrical or plumbing lines.
How to cut a channel in concrete wall.
Score the length of the cut three or four times with the chisel.
Several consecutive blows should do the trick.
Cutting and filling chases in brick and concrete walls for wiring and cables and filling for plastering.
Hammer the chisel into the concrete and continue doing so until you have formed a groove.
Dont go too deep in the slab there might be a membrane dpm below the slab.
Proceed slowly maintaining minimum rpms of the cut off saw.
Apply the line as thick as possible.
This saw will cut concrete without the expense of renting or buy.
Locate the area of the concrete floor where you would like to cut the channel.
Ree 19 nov 2014.
Cut in 5 6mm deep passes and chisel out the slot if you hit wire mesh just go thro it.
Keep your nondominant foot facing the cutline at a 45 degree angle.
Don safety glasses hearing protection and steel toed boots for protection.
For this diy project guide we show you the process of cutting chases in walls including brick and concrete walls using a chase cutter and then how to run your conduit and cables into the chase and then refill it ready for plastering.
Face your dominant foot outward from the saw perpendicular to the cutline.
You ll ideally run a trickle of water.
How to cut a shallow channel into a concrete floor.
Turn on the saw blade and slowly allow the cutter to enter the concrete.
If your cut doesn t need to be exact use a cold chisel and hand sledge to cut the concrete.
A circular saw with a masonry blade can also be used to either score or completely cut through the block.
Walk behind the concrete cutter.
Angle grinder or circular saw chucked with a masonry blade.
Connect one end of a.
Step 5 install the pipes to finish the job mix the cement and spread a layer about 3 inches thick around the mouth and sides of the drainage channel.
It will be gas powered and put out a lot of fumes.
In one hand take a chisel and place the edge at one end of the mark in the concrete.
With the jackhammer cut the drainage channel down to where you dug the trench in your yard so that the water will flow in the correct direction.
Don t force a blade into a cut.
Then repeat the process at the other end of the cut mark until the groove forms a channel.
The blades have a predetermined depth of 2 inches.
Mark the places you want to cut on the concrete slab either using chalk line good for long straight edges or chalk.
