Rinse and wring between each tile.
How to clean newly laid wall tiles.
Wipe the tiles using a soft cloth dipped in the vinegar mixture.
For a thorough clean use the miracle tile stone cleaner available from beaumont tiles with warm water and a damp microfibre mop.
Patch any holes or cracks with spackling compound and sand the entire surface with medium grit sandpaper.
Dampen a clean sponge and wring it out so that it s slightly damp.
Additional vinegar can be added for extra strength.
Scrape the wall to remove any texture and to create a flat surface.
It is important to rinse the sponge as you go to avoid leaving traces of mortar difficult to remove once dry.
Wash the tiles again with plain water to remove any remaining vinegar.
When you re laying the tiles.
A damp microfibre mop is better than a wet mop for a streak free clean avoid the use of cotton and sponge mops.
To use vinegar on porcelain or ceramic mix four parts water with one part white vinegar.
Remove traces of adhesive mortar on the tiles with a damp sponge that you ll rinse frequently.
Run a dry cloth over the tiles to remove any leftover and dry the floor.
The mop should grab the surface and lift off most daily grime with a little pressure.
Vacuum to remove dust.
Remove any remaining dust oils and grease from the wall with tsp tri sodium phosphate or an ammonia based cleanser.
Mix 1 part white vinegar to 4 parts water in a bucket or large spray bottle.
I simply searched tile safety in the bathroom there is a section about tiles and how they must comply with australian safety regulations and that some imported tiles do not meet this compliance.
Depending on the surface area you must cover use a mop or soft.